January 19, 2007—3M expands its line of cold shrink products for high-voltage applications with the first termination kits for 69/72,5kV reduced-wall cable. The first high-voltage cold shrink product, a termination kit for 69kV standard-wall cable, was introduced in 2005.
The 3M cold shrink silicone rubber termination kits QT-III,7672-S- (RW) for 69/72,5kV are designed for indoor or outdoor use and to be highly reliable: they meet or exceed the requirements of IEC 60840 for 72,5kV, and solid dielectric insulation, such as PE, XLPE, and EPR shielded high-voltage cables.
Additionally, says the company, the new 3M termination is easier to install than other termination technologies, requiring no tools or heat source. Its light weight means that a crane is not required to install the termination. The simpler installation process can make possible a lower total installed cost and help reduce craft errors that may threaten reliability.
The new termination kit is designed to accommodate a wide range of cables and solid dielectric insulations in thicknesses of 400-mil to 470-mil (10.2 to 11.9 mm). It is rated for 325kV BIL performance levels and covers a conductor size range of 250-2000 kcmil (120-1000 square millimeters).
Once applied, the cold shrink tube creates a dynamic, compressive environmental seal and electrical interfacewithout sealants or adhesives—and resists ultraviolet radiation, ozone, and industry-approved cable cleaners.
3M points out that its Cold Shrink Terminations installed more than 25 years ago are still in service.
For more information visit the 3M Web site.
